Run-through video showing the process behind servicing the rear main seal and also remove / install of the valve-body on the transmission.
Unfortunately there is no exact step by step process, but more just a general showcase of the overall process.
Contents:
0:00 - Intro
0:28 - Prop Shaft Removal & Exhaust
1:55 - Selector removal for shifter
7:25 - Electric connector cover & fitting
9:40 - Removal of ground cable
10:50 - O2 Sensor Harness & carrier
13:10 - Drain oil from pan
13:50 - Access port for fly wheel
14:34 - Detach oil cooler lines & main bell housing bolts
15:40 - Pull out transmission & lower
16:27 - Inspection of transmission
18:18 - Rear main seal
41:30 - Install flex plate
44:54 - Install gear box
---------------------
(C)2013 Matty231 Production | www.youtube.com/matty231
Unfortunately there is no exact step by step process, but more just a general showcase of the overall process.
Contents:
0:00 - Intro
0:28 - Prop Shaft Removal & Exhaust
1:55 - Selector removal for shifter
7:25 - Electric connector cover & fitting
9:40 - Removal of ground cable
10:50 - O2 Sensor Harness & carrier
13:10 - Drain oil from pan
13:50 - Access port for fly wheel
14:34 - Detach oil cooler lines & main bell housing bolts
15:40 - Pull out transmission & lower
16:27 - Inspection of transmission
18:18 - Rear main seal
41:30 - Install flex plate
44:54 - Install gear box
---------------------
(C)2013 Matty231 Production | www.youtube.com/matty231
- Category
- 722.6
Commenting disabled.