Show menu

Automatic Transmission Problems on Volkswagen and Audi How to Reset and Fix - Quick and Easy!

Thanks! Share it with your friends!

You disliked this video. Thanks for the feedback!


Added by MiAmigo
61 Views
In this video I demonstrate and describe the brief process on how to reset the engine and transmission control modules on VW, Audi, Skoda, and Seat vehicles built starting in the late 1990s equipped with an electronic drive-by-wire throttle. The steps to reset these modules is as follows:

1/ Get into the passenger side drivers seat of the vehicle;
2/ Close the Drivers Door;
3/ Lock all of the Vehicles Doors;
4/ Switch the Ignition to the Accessory position;
5/ Wait for at least 15 seconds
6/ Push the Accelerator Pedal all the way down (as far as it will go) and hold it there for at least 30 seconds;
7/ Whilst still holding the Accelerator Pedal down switch off the Ignition ;
8/ Switch of the Ignition;
9/ Remove your foot from the Accelerator pedal;
10/ Remain sitting in the car (with all of the doors locked) for at least 3 minutes;
11/ Start the Vehicle
12/ Drive the Vehicle how you would normally drive for 15 minutes.

By following the procedure outlined in this video it may help resolve potential transmission issues in your vehicle, but be advised that this is not a substitute for having a professional technician resolve major internal mechanical issues in your engine or transmission if the vehicle continues to have issues after performing this procedure.

I trust that you enjoy the video!
Category
722.6
Commenting disabled.

Up Next